I put an led mod on my dualshock 3 controller and went to pair it with my ps3 and on the xmb it was rolling to the left and staying, I would move it to the right but it goes and stays to the left, I was wondering has this happened to anyone else, and did I ruin my controller. Could use your advise.
you modified your controller and now its not working correctly. Yes you have ruined your controller Did you really need the internet to figure that one out? Undo your handy work and pray that it fixes it
It could be that the controller was face down and calibrated incorrectly because the analog stick was being held down when the controller was turned on, but most likely, your mod screwed up something.
Maybe if your mod involved drilling holes then you maybe made a contact between the 2 plates which judge how the analogue moves... Or maybe a stray piece of "mod" has connected those contact plates...
you should probly open it up again and check out what you did wrong. something must be pinched. my first controller crawls forwrd at all times....but that was just overuse
I've taken it apart countless time and one of the times everything was working except the the left analog stick was inactive, so I took it apart again and It was doing the same thing and going to the left, I don't know what's going on, could the solder have done something? Again I only soldered the positive and negative points on the dualshock.
I put an led mod on my dualshock 3 controller and went to pair it with my ps3 and on the xmb it was rolling to the left and staying, I would move it to the right but it goes and stays to the left, I was wondering has this happened to anyone else, and did I ruin my controller. Could use your advise.chizzim007
i figured it out when i was soldering the negative and positive wires there was solder some left over which was making the two points touch which was making my controllers act up and move to the left on the xmb. now me controllers are looking awesome with the leds shinning.
Log in to comment