lol duh i remember look too much into it untill i built the case but makes sense.

the jumper connects the two pins together with metal good contact between the two and when you hold down the power button it's making metal contact with the 2 pins causing the pc to shut down like leaving the jumper in after booting the board up it's like running the pc holding down the power button.

after the board boots up you gotta take the jumper off if you leave it on the board will shut down.

putting one of these jumpers where power button wire plugs into and the board will turn on.

people always say touch the contats with a screw driver on a motherboards front panel head to turn the board on without a power button.

my button wouldnt do this i found out if you use a jumper pin it will turn on though.

i made my own form factor i didnt have wood for sides so i just put the vga port coming out the side of the case i might leave it like that or make it into atx when i get some sides for it.

no computers on market with display port on the side lulz all out the back.

lol stock fan was too loud so i just taped a different fan onto it

ended up with this lol.

Started off with this