2 beeps on boot and no display (just finished build)

Here's a list of the parts used:

SONY Black SATA DVD-ROM Drive Model DDU1681S-0B

XFX HD-679X-ZDFC Radeon HD 6790 1GB 256-bit GDDR5 PCI Express 2.1 x16 HDCP Ready CrossFireX Support Video Card

Intel Core i3-2100 Sandy Bridge 3.1GHz LGA 1155 65W Dual-Core Desktop Processor BX80623I32100

Western Digital Caviar Blue WD3200AAKX 320GB 7200 RPM SATA 6.0Gb/s 3.5" Internal Hard Drive -Bare Drive

G.SKILL Ripjaws Series 4GB (2 x 2GB) 240-Pin DDR3 SDRAM DDR3 1333 (PC3 10666) Desktop Memory Model F3-10666CL8D-4GBRM

Rosewill Green Series RG530-S12 530W Continuous @40°C, 80 PLUS Certified, Single 12V Rail, Active PFC "Compatible with Core i7,i5" Power Supply

MSI H61M-E33 (B3) LGA 1155 Intel H61 HDMI Micro ATX Intel Motherboard

Thermaltake V3 Black Edition VL80001W2Z Black SECC / Plastic ATX Mid Tower Computer Case

After putting everything together and booting up the computer I get 2 beeps that repeat after a little while. Also my monitor does not display anything, saying "No Display"

I've ran through the machine a couple times to make sure everything was put together correctly and I'm not sure what to do.

Suggestions??

tl;dr probably ramJigglyWiggly_

so RAM is probably DOA then?? Couldn't check since my other builds were older mobos and used DDR2 RAM.

Check the MB manual, it should list what your problem is from the beeps you get.neatfeatguy

I can't find anything in the manual that mentions beeping noises

[QUOTE="neatfeatguy"]Check the MB manual, it should list what your problem is from the beeps you get.Katanas

I can't find anything in the manual that mentions beeping noises

Hope this helps:

Edit: Sorry formatting is messed up.
Check out this link then.